P&S Bug off Insect Remover
P&S Bug Off Insect Remover is a powerful, ready-to-use cleaner designed to quickly break down and remove stubborn bug splatter, insect residue, and acidic contamination from your vehicle’s exterior.
Key Benefits
- Fast Acting Formula: Quickly breaks down bug splatter, residue, and insect acids.
- Prevents Paint Damage: Neutralises acidic contaminants that can harm clear coat.
- Spray-On, Rinse-Off: Simple and efficient application as part of your wash routine.
- Industrial-Strength Cleaning: Removes even heavy, baked-on insect deposits.
- Paint Safe: Proven safe for use on automotive paintwork when used as directed.
- Ready-to-Use: No dilution required for optimal cleaning performance.
How to Use
- Surface Prep: Ensure the paint surface is cool to the touch and out of direct sunlight.
- Apply: Spray P&S Bug Off directly onto affected areas with insect residue.
- Dwell: Allow the product to sit for 1–2 minutes to break down contamination.
- Do Not Dry: Do not allow the product to dry on the surface.
- Rinse: Thoroughly rinse the treated area with clean water.
- Wash: Follow up with a full vehicle wash for best results.
PRO TIP: Bug splatter contains acidic residues that can damage clear coat if left untreated. Using Bug Off as a pre-wash step helps protect your paint and makes the washing process faster and safer.
Safety Note: Always wear appropriate PPE such as gloves, eye protection, and suitable clothing when using strong cleaning products.
Dilution calculator
Pick your container and your ratio, and read off how much concentrate to pour.
A foam cannon does not spray its bottle. It draws from the bottle into the pressure washer's flow, so a 1 L bottle can put 11 L on the car and the ratio in the bottle tells you nothing about what reaches the paint. Measure your setup once and the number holds for every product that quotes a PIR.
Nothing matches that. Check the product's own page for its ratio.
Common questions
-
Parts water to one part product. A 10:1 mix is ten parts water and one part product, so a 1 L bottle takes 91 ml of product and 909 ml of water. A few brands print theirs the other way round, so check the label if a number looks unusually strong.
-
Water first, then the concentrate. Pouring concentrate into an empty bottle and topping it up makes it foam over the top, and you lose some of what you just measured.
-
Most diluted products keep for a few weeks in a sealed, labelled bottle out of sunlight. Write the product and the ratio on the bottle. An unlabelled trigger bottle is how the wrong chemical ends up on someone's interior.
-
Panel Impact Ratio is the concentrate as a percentage of everything leaving a foam cannon, the bottle water and the pressure washer water together. It matters for snow foam and pre-wash only, because a cannon draws from its bottle into the washer's flow rather than spraying the bottle.
-
A syringe or a measuring jug with millilitre graduations. Capfuls vary by bottle and by how full you fill them, and at 256:1 a few millilitres out is a noticeable change in strength.