P&S Undress Tyre Cleaner
P&S Undressed is a premium tyre cleaner and dressing remover engineered to strip away old tyre dressings, browning, road grime, and embedded contamination.
Key Benefits
- Deep Cleans Tyres: Effectively removes road grime, old dressings, oxidation, and tyre browning.
- Prepares for New Dressing: Leaves tyres completely clean, allowing dressings to bond better and last longer.
- Powerful Yet Safe Formula: Strong cleaning performance without damaging modern tyre compounds when used as directed.
- Restores Natural Rubber Appearance: Removes contamination to reveal a clean, factory-fresh finish.
- Professional-Level Results: Ideal for enthusiasts and detailers who want maximum dressing performance.
- Fast & Easy to Use: Quickly breaks down stubborn contamination with minimal effort.
Recommended Use
- Tyre cleaning
- Removing old tyre dressings
- Eliminating tyre browning
- Preparing tyres before applying dressing
- Routine tyre maintenance
How to Use
- Rinse the Tyres: Remove loose dirt and debris before cleaning.
- Apply Undressed: Spray generously onto the tyre sidewall.
- Agitate Thoroughly: Scrub using a dedicated tyre brush until the product begins lifting contamination.
- Rinse Completely: Flush away loosened dirt and old dressing.
- Repeat if Required: Continue cleaning until the foam remains white, indicating the tyre is fully decontaminated.
- Dry Before Dressing: Allow the tyre to dry completely before applying your preferred tyre dressing.
PRO TIP: The secret to long-lasting tyre shine isn't the dressing—it's the preparation. Continue cleaning until the foam stays white rather than brown. This ensures all old dressing and contamination has been removed, allowing your tyre dressing to bond properly and deliver maximum durability.
Dilution calculator
Pick your container and your ratio, and read off how much concentrate to pour.
A foam cannon does not spray its bottle. It draws from the bottle into the pressure washer's flow, so a 1 L bottle can put 11 L on the car and the ratio in the bottle tells you nothing about what reaches the paint. Measure your setup once and the number holds for every product that quotes a PIR.
Nothing matches that. Check the product's own page for its ratio.
Common questions
-
Parts water to one part product. A 10:1 mix is ten parts water and one part product, so a 1 L bottle takes 91 ml of product and 909 ml of water. A few brands print theirs the other way round, so check the label if a number looks unusually strong.
-
Water first, then the concentrate. Pouring concentrate into an empty bottle and topping it up makes it foam over the top, and you lose some of what you just measured.
-
Most diluted products keep for a few weeks in a sealed, labelled bottle out of sunlight. Write the product and the ratio on the bottle. An unlabelled trigger bottle is how the wrong chemical ends up on someone's interior.
-
Panel Impact Ratio is the concentrate as a percentage of everything leaving a foam cannon, the bottle water and the pressure washer water together. It matters for snow foam and pre-wash only, because a cannon draws from its bottle into the washer's flow rather than spraying the bottle.
-
A syringe or a measuring jug with millilitre graduations. Capfuls vary by bottle and by how full you fill them, and at 256:1 a few millilitres out is a noticeable change in strength.