P&S Frostbite High PH Snow Foam
P&S Frostbite Snow Foam is a high-foaming, high-pH pre-wash cleaner designed to break down heavy dirt, road salt, and grime before contact washing.
Key Benefits
- High-Foam Pre-Wash: Dense, clinging foam maximises dwell time and coverage.
- Powerful Cleaning Action: High pH formula cuts through heavy grime, road salt, and buildup.
- Lubrication Focused: Helps minimise wash-induced marring during the pre-wash stage.
- Surface Safe: Suitable for paint, glass, plastic trim, and metal surfaces.
- Multi-Use Versatility: Works as a snow foam or a strong bucket wash detergent.
- Fresh Fragrance: Clean floral scent enhances the washing experience.
How to Use
- Pre-Rinse: Rinse the vehicle to remove loose debris and cool the surface.
- Foam: Add Frostbite to a foam cannon, dilute as required, and apply evenly.
- Dwell: Allow foam to dwell and break down contamination without drying.
- Rinse: Rinse thoroughly with a strong stream of water.
- Wash: Follow with a contact wash or use Frostbite in a bucket for added cleaning power.
PRO TIP: Use Frostbite as a dedicated pre-wash on heavily soiled vehicles, then follow with a pH-neutral shampoo for the safest possible two-stage wash process.
Dilution calculator
Pick your container and your ratio, and read off how much concentrate to pour.
A foam cannon does not spray its bottle. It draws from the bottle into the pressure washer's flow, so a 1 L bottle can put 11 L on the car and the ratio in the bottle tells you nothing about what reaches the paint. Measure your setup once and the number holds for every product that quotes a PIR.
Nothing matches that. Check the product's own page for its ratio.
Common questions
-
Parts water to one part product. A 10:1 mix is ten parts water and one part product, so a 1 L bottle takes 91 ml of product and 909 ml of water. A few brands print theirs the other way round, so check the label if a number looks unusually strong.
-
Water first, then the concentrate. Pouring concentrate into an empty bottle and topping it up makes it foam over the top, and you lose some of what you just measured.
-
Most diluted products keep for a few weeks in a sealed, labelled bottle out of sunlight. Write the product and the ratio on the bottle. An unlabelled trigger bottle is how the wrong chemical ends up on someone's interior.
-
Panel Impact Ratio is the concentrate as a percentage of everything leaving a foam cannon, the bottle water and the pressure washer water together. It matters for snow foam and pre-wash only, because a cannon draws from its bottle into the washer's flow rather than spraying the bottle.
-
A syringe or a measuring jug with millilitre graduations. Capfuls vary by bottle and by how full you fill them, and at 256:1 a few millilitres out is a noticeable change in strength.