DIY Detail Rinseless Wash V2
DIY Detail Rinseless Wash is a fast, eco-friendly solution for safely cleaning your vehicle without the need for a hose.
Key Benefits
- Rinseless Convenience: Wash and dry without a hose, saving time and water.
- Paint-Safe Lubrication: High lubricity helps minimise the risk of marring during contact washing.
- pH-Balanced Formula: Safe for paint, glass, trim, wheels, and existing coatings.
- Glossy, Streak-Free Finish: Leaves surfaces clean, smooth, and ready to protect.
- Mobile & Garage Friendly: Ideal for apartments, workshops, and water-restricted areas.
- Eco-Conscious Cleaning: Uses significantly less water than traditional washing methods.
How to Use
- Hand Wash Mix: Add 30 mL of Rinseless Wash to 7.5 L of water in a bucket.
- Load: Soak a plush wash mitt or sponge fully in the solution.
- Wash: Clean one section at a time using straight-line motions.
- Dry: Dry each panel immediately with a premium microfiber drying towel.
- Foam Option: For heavier grime, apply via foam cannon at 120–150 mL and allow brief dwell.
PRO TIP: Use multiple clean towels or mitts during a rinseless wash to further reduce the chance of dragging dirt across the surface—especially on darker paint.
Dilution calculator
Pick your container and your ratio, and read off how much concentrate to pour.
A foam cannon does not spray its bottle. It draws from the bottle into the pressure washer's flow, so a 1 L bottle can put 11 L on the car and the ratio in the bottle tells you nothing about what reaches the paint. Measure your setup once and the number holds for every product that quotes a PIR.
Nothing matches that. Check the product's own page for its ratio.
Common questions
-
Parts water to one part product. A 10:1 mix is ten parts water and one part product, so a 1 L bottle takes 91 ml of product and 909 ml of water. A few brands print theirs the other way round, so check the label if a number looks unusually strong.
-
Water first, then the concentrate. Pouring concentrate into an empty bottle and topping it up makes it foam over the top, and you lose some of what you just measured.
-
Most diluted products keep for a few weeks in a sealed, labelled bottle out of sunlight. Write the product and the ratio on the bottle. An unlabelled trigger bottle is how the wrong chemical ends up on someone's interior.
-
Panel Impact Ratio is the concentrate as a percentage of everything leaving a foam cannon, the bottle water and the pressure washer water together. It matters for snow foam and pre-wash only, because a cannon draws from its bottle into the washer's flow rather than spraying the bottle.
-
A syringe or a measuring jug with millilitre graduations. Capfuls vary by bottle and by how full you fill them, and at 256:1 a few millilitres out is a noticeable change in strength.