P&S Absolute Rinseless Wash
P&S Absolute Rinseless Wash delivers a slick, efficient, and water-saving cleaning solution that allows you to safely wash your vehicle anywhere, anytime.
Key Benefits
- Rinseless Formula: Wash your vehicle without the need for a hose.
- Water Softening Technology: Instantly reduces hard water spotting.
- Ultra-Slick Finish: Helps minimise the risk of swirl marks while cleaning.
- Multi-Surface Safe: Suitable for paint, coatings, wraps, PPF, trim, plastics, leather, and upholstery.
- Versatile Use: Can be used as a rinseless wash, quick detailer, clay lubricant, or interior cleaner.
- Perfect for Any Location: Ideal for garages, mobile detailing, apartments, or water-restricted areas.
How to Use (Rinseless Wash)
- Preparation: Ensure the vehicle is cool and dry to the touch. Shade is preferred.
- Dilution: Add 30ml of Absolute to 7.5L of water (256:1) in a wash bucket.
- Load Wash Media: Submerge a wash mitt or multiple microfibre towels and mix thoroughly.
- Wash: Wipe the vehicle from top to bottom, squeezing excess solution from the mitt before each pass.
- Repeat: Frequently return to the bucket to reload clean solution.
- Dry: No rinsing required. Immediately dry each panel with a plush microfibre towel.
Dilution Guide
- Rinseless Wash: 256:1 (30ml in 7.5L of water)
- Quick Detailer: 64:1
- Clay Lubricant: 128:1
- Glass & Interior Cleaning: 256:1
PRO TIP: Pre-treat heavily soiled areas using the same 256:1 dilution in a trigger sprayer. Wipe the panel clean, then dry immediately with a plush microfibre towel for a smooth, spot-free finish.
Absolutely Clean. Absolutely Efficient. Absolutely Absolute.
Dilution calculator
Pick your container and your ratio, and read off how much concentrate to pour.
A foam cannon does not spray its bottle. It draws from the bottle into the pressure washer's flow, so a 1 L bottle can put 11 L on the car and the ratio in the bottle tells you nothing about what reaches the paint. Measure your setup once and the number holds for every product that quotes a PIR.
Nothing matches that. Check the product's own page for its ratio.
Common questions
-
Parts water to one part product. A 10:1 mix is ten parts water and one part product, so a 1 L bottle takes 91 ml of product and 909 ml of water. A few brands print theirs the other way round, so check the label if a number looks unusually strong.
-
Water first, then the concentrate. Pouring concentrate into an empty bottle and topping it up makes it foam over the top, and you lose some of what you just measured.
-
Most diluted products keep for a few weeks in a sealed, labelled bottle out of sunlight. Write the product and the ratio on the bottle. An unlabelled trigger bottle is how the wrong chemical ends up on someone's interior.
-
Panel Impact Ratio is the concentrate as a percentage of everything leaving a foam cannon, the bottle water and the pressure washer water together. It matters for snow foam and pre-wash only, because a cannon draws from its bottle into the washer's flow rather than spraying the bottle.
-
A syringe or a measuring jug with millilitre graduations. Capfuls vary by bottle and by how full you fill them, and at 256:1 a few millilitres out is a noticeable change in strength.