P&S All Purpose Cleaner
P&S All Purpose Cleaner is a powerful, highly versatile solution designed to cut through dirt, grease, and grime on a wide range of interior and exterior surfaces.
Key Benefits
- Fast-Acting Cleaning Power: Breaks down grease and lifts stubborn dirt quickly.
- True Multi-Surface Use: Safe for vinyl, rubber, plastics, carpets, upholstery, tyres, rims, and engine bays.
- Highly Concentrated: Dilute to suit the task, making it extremely cost-effective.
- Residue-Free Finish: Rinses clean without streaks or films.
- Pleasant Scent: Leaves surfaces fresh without harsh chemical odours.
- Workshop & Eco Friendly: Effective yet responsible when used as directed.
How to Use
- Dilute: Mix APC to suit the task—4:1 for heavy-duty, 10:1 for general cleaning, 15:1 for interiors, or 20:1 for light maintenance.
- Apply: Spray directly onto the surface or onto a brush or microfiber towel.
- Agitate: Work the product using a detailing brush or towel as required.
- Rinse/Wipe: Rinse thoroughly or wipe clean with a damp microfiber towel.
- Dry: Allow to air dry or finish with a clean towel for best results.
PRO TIP: Start with a lighter dilution and increase strength only if needed.
Dilution calculator
Pick your container and your ratio, and read off how much concentrate to pour.
A foam cannon does not spray its bottle. It draws from the bottle into the pressure washer's flow, so a 1 L bottle can put 11 L on the car and the ratio in the bottle tells you nothing about what reaches the paint. Measure your setup once and the number holds for every product that quotes a PIR.
Nothing matches that. Check the product's own page for its ratio.
Common questions
-
Parts water to one part product. A 10:1 mix is ten parts water and one part product, so a 1 L bottle takes 91 ml of product and 909 ml of water. A few brands print theirs the other way round, so check the label if a number looks unusually strong.
-
Water first, then the concentrate. Pouring concentrate into an empty bottle and topping it up makes it foam over the top, and you lose some of what you just measured.
-
Most diluted products keep for a few weeks in a sealed, labelled bottle out of sunlight. Write the product and the ratio on the bottle. An unlabelled trigger bottle is how the wrong chemical ends up on someone's interior.
-
Panel Impact Ratio is the concentrate as a percentage of everything leaving a foam cannon, the bottle water and the pressure washer water together. It matters for snow foam and pre-wash only, because a cannon draws from its bottle into the washer's flow rather than spraying the bottle.
-
A syringe or a measuring jug with millilitre graduations. Capfuls vary by bottle and by how full you fill them, and at 256:1 a few millilitres out is a noticeable change in strength.